$264 monthly/$88 weekly
A one-time setup/calibration charge in addition to rental rate noted above may also apply. When this applies, you’ll be informed of the amount of the additional charge at time of order or, if requested, prior to placement of order.
- With cable for RS-232 data out put to computer, GPS, or serial printer
- Outputs scaler count upon completion or output ratemeter count every 2 seconds as CPM
- 6 Decade LCD Scaler with backlight
- Logarithmic and Linear Ratemeter with a Total Counting Range from 0 - 500,000 cpm
- Headset Compatible
- Audio Divide
- Single Channel Analyzer
INDICATED USE:
Field analysis
COMPATIBLE DETECTORS:
G-M, proportional, scintillation
CONNECTOR:
Series "C" (others available)
AUDIO:
Built in unimorph speaker with volume control (greater than 60 dB at 2 feet, full volume)
AUDIO DIVIDE:
Thumb switch for 1, 10, or 100 events-per-click
AUDIO JACK:
For optional headset
METER DIAL:
0 - 500 cpm; 50 - 500k cpm logarithmic scale (others available)
MULTIPLIERS:
X1, X10, X100, X1k, and LOG for logarithmic scale
LINEARITY:
Reading within plus or minus 10% of true value with detector connected
DIGITAL DISPLAY:
6 digit LCD display with 0.5" (1.3cm) digits
LCD BACKLIGHT:
Activated by LAMP switch
DIGITAL RATEMETER:
Provides a digital display of count rate when selector switch is in Dig. Rate position
SCALER: Used in conjunction with timer to allow for gross counting with range from 0 - 999999 counts when selector switch is in Scaler position (controlled by COUNT and HOLD buttons). NOTE: Scaler and digital ratemeter are active when not selected, allowing for concurrent use
TIMER:
Switch selectable divisions of 0.1, 0.5, 1, 2, 5, 10 minutes or CONT (continuous ) for manual timing
CALIBRATION CONTROLS:
Accessible from front of instrument (protective cover provided)
HIGH VOLTAGE:
Adjustable from 200 - 2400 volts (can be checked on display)
THRESHOLD:
Adjustable from 100 - 1000 (can be checked on display)
WINDOW:
Adjustable from 0 - 1000 above threshold setting (can be turned on or off)
GAIN:
Adjustable from 1.5 - 100 mV at threshold setting of 100
OVERLOAD:
Senses detector saturation. Indicated by "------" on LCD display and meter going to full scale (adjustable depending on detector selected)
RESPONSE:
Toggle switch for FAST (4 seconds) or SLOW (22 seconds) from 10% to 90% of final reading
RESET:
Push-button to zero meter
POWER:
4 each "D" cell batteries (housed in sealed compartment that is externally accessible)
BATTERY LIFE:
Typically 250 hours with alkaline batteries (battery condition can be checked on digital display)
METER:
2.5"(6.4cm) arc, 1 mA analog type
CONSTRUCTION:
Milled and drawn aluminum with beige polyurethane enamel paint
TEMPERATURE RANGE:
-4° F(-20° C) to 122° F(50° C)
May be certified for operation from -40° F(-40° C) to 150° F(65° C)
SIZE:
9"(22.9cm)H X 4.3"(10.9cm)W X 10"(25cm)L including handle
WEIGHT:
5.5 lbs (2.5kg) including batteries
